N5JFJ    |   home About N5JFJ   |   For Trade... or Maybe Sell ?   |   Fun Photo Album   |   Ham Radio Friends   |   SteppIR Fluid Motion Beam   |   My Favorite Ham Links +   |   Mailbag   |   Family Photos   |   Whats Happening Lately?   |   In Loving Memory:   |   Contact Me   |   N5JFJ Radio Equipment   |   Hurricane IKE SteppIR Fluid Motion Beam Check on Down my Page to see the Progress...from arrival to install - And honestly on Christmas Eve night, My lovely Wife and I were able to put the STEPPIR 3 Element Boom assembly together as well as set the Motors and wire this whole assembly (Test Mode, and working as instructed) in about 3 Hrs! Sit Back and most important "READ FIRST + READ STEP -- BY STEP+ AND FOLLOW EVERY INSTRUCTION" Together She even commented..."Honey this wasn't so hard to do!" "Thank you, to my loving, supportive Wife" "My OPINION" - STEPPIR = 100% SATISFIED. Update: It's been 3 years now... and I'm still SATISFIED. This is a Steppir Control Motor The Computer Steppir Beam controller The Steppir Boom system ready for motors to mount on Steppir Telescopic extendable Elements - Just pull them out and lock Steppir Cable assembly Ready to plug in to the Controller Boom and Steppir Motors constructed and Harnessed for lifting Laying it out Square - will help you adjust the Boom connections A shot of the Wiring Harness PVC Ho;der and Mounted to the boom The Fiberglass Steppir Elements assmbled, Taped, and Ready to go! NOTICE...BECAUSE OF WHAT ANOTHER STEPPIR OWNER HAD WRITTEN THAT i WENT AHEAD AND I TAPED THE "RUBBER BOOTS" BECAUSE OF CRACKS THEY REPORTED AFTER USING IT AWHILE. WHAT THE HECK...IT'S ONLY A LITTLE MORE TAPE!!! Probably Over-Kill but here is the Bearing Head  Assembly of my Tower MY...HOME-MADE - TRAILER - "QUICK CONNECT ROTOR PLUGS"  THE TOWER...READY FOR THE STEPPIR The New STEPPIR installed and YES...It works "WONDERFUL" FINALLY...Thanks to my Wife, Step Son Nick and His Girlfriend Kindra...we got er DONE! Here they are below...and Thank you my Family...for your loving Patience...with this project. The Grand Old HeathKit Remote Switch-Box Below...my simple welded Pulley and reducing coupling. My HomeMade Gin Pole assembly using 1 & 1/2"  Rigid Aluminum Conduit Muffler clamps...with FlatBar welded to the Clamps. a shot of the Gin Pole using Muffler Clamps and Flat Bar welded to them This simple homemade Gin =Pole did everything we needed....to install the steppir.